U-Joint U-Bolt Kit for 1330 Yoke

9" Pinion Seal

High-performance non-synthetic racing gear oil meets the API GL-6 specification and is designed specifically for the requirements of 9-inch gear assemblies. Provides maximum shear stability and extreme pressure protection required to extend the life of your Currie rearend.

9", 8", 8.8" & High Pinion 9" Pinion Nut

Oil service kit for Ford 9-inch rearends includes 3 liters of Currie 85w-140 Racing Gear Oil, third member gasket and 10 nyloc nuts and aluminum crush washers

Friction Modifier (Ford)

9" Pinion Seal

1330 Nodular Yoke - 9" (Short Style for Std Pinion Support)

Snap-On Brake Line Clip (3" Tube)

Housing Vent - Cap Style (1/8" Pipe Thread)

U-Joint U-Bolt Kit for 1350 Yoke (Plated)

Decal (4 1/2" x 2 1/2")

Front Inner Axle Seal - 31 Spline 9" & 30 Spline RockJock® & Dana 44

Complete, ready-to-run, drop-in nodular iron case 9-inch third member set up for 28-spline axles. Options include choice of differential type and gear ratio

***CONFIGURE OPTIONS TO SEE FULL PRICE***

The Currie exclusive EZ-Deflator Pro is the next generation of tire deflators! Features include an illuminated digital gauge, extended tip for easy use on beadlock wheels and a light on the back so you can find your valve stems in the dark!

Currie Can Cooler

*** SELECT OPTIONS TO BUILD AND PRICE ***

Included In Price:

• Currie Centurion 9-Inch Notchback Housing For Mustang And Cougar
• Currie Sportsman Nodular Iron Gear Case With Daytona Pinion Support
• Timken Master Bearing Kit And Solid Pinion Spacer
• Currie Performance 31-Spline Axles With Timken Bearings
• 1330 Nodular Iron Pinion Yoke
• Professionally Setup And Assembled

1330 Nodular Yoke - 9" (Long Style for Std Pinion Support)

Brake Hose Bulkhead Fitting Clip

1310 Yoke - 8" Ford (Reconditioned)

Stainless Steel Hard Brake Line Kit (Universal)

Parking Brake Cable Kit for Drum Brakes (Universal)

Universal rubber brake hose & steel hydraulic hard brake line kit for rear axles includes 2 rubber brake line hoses and 2 lengths of steel hard line tubing. One hose specifically fits and easily bolts on to the 3rd. member studs of a 9" Ford rearend and features the 3/16" double flare bulkhead fitting at the frame end, and a block at the housing end with two 3/16" double flare inlets. The second hose is designed for universal mounting on any rearend (where this hose provides enough travel) and features the 3/16" double flare bulkhead fitting on the frame end and brass distribution block on the housing end that features a .270" mounting hole through it. Hard lines in this kit feature one at 30" long and one at 40" long, that are flared on both ends. Steel flare nut fittings are 3/8"-24 thread and lines feature 3/16" double flare at both ends. NOTE: Tubing bending and generally flaring equipment is necessary for the installation of this kit!!!

8" Pinion Seal

9" Solid Spacer & Shim Kit (for Standard Pinion Support)