CE-9028 - Housing Vent - Cap Style (1/8" Pipe Thread)

Housing Vent - 45 Degree Nipple Style (1/8" Pipe Thread/1/4" Hose)

Housing Vent - Nipple Style (1/8" Pipe Thread/3/8" Hose)

Housing Vent - Long Nipple Style (1/8" Pipe Thread/3/8" Hose)

Housing Vent - Nipple Style (1/8" Pipe Thread/5/16" Hose)

3/8" Housing End T-Bolt w/ Lock Nut

1/2" Wheel Stud w/ Washer (2" Long Screw-In)

CE-2010 - 1/2" Housing End T-Bolt w/ Lock Nut (Good Used)

Snap-On Brake Line Clip (3" 1/4" Tube)

Drum Brake Wheel Cylinder Bolt (Good Used)

Drum Brake Wheel Cylinder Push Rod

Drum Brake Shoe Retainer

11" Drum Brake Shoe Spreader Bar

Spreader Bar Return Spring (10" or 11" Drum Brakes)

11" Drum Brake Parking Brake Arms (Pair)

Oil service kit for Ford 9-inch rearends includes 3 liters of Currie 85w-140 Racing Gear Oil, third member gasket and 10 nyloc nuts and aluminum crush washers

Snap-On Brake Line Clip (3" Tube)

Universal rubber brake hose & steel hydraulic hard brake line kit for rear axles includes 2 rubber brake line hoses and 2 lengths of steel hard line tubing. One hose specifically fits and easily bolts on to the 3rd. member studs of a 9" Ford rearend and features the 3/16" double flare bulkhead fitting at the frame end, and a block at the housing end with two 3/16" double flare inlets. The second hose is designed for universal mounting on any rearend (where this hose provides enough travel) and features the 3/16" double flare bulkhead fitting on the frame end and brass distribution block on the housing end that features a .270" mounting hole through it. Hard lines in this kit feature one at 30" long and one at 40" long, that are flared on both ends. Steel flare nut fittings are 3/8"-24 thread and lines feature 3/16" double flare at both ends. NOTE: Tubing bending and generally flaring equipment is necessary for the installation of this kit!!!

U-Joint U-Bolt Kit for 1330 Yoke

Billet Late Model Large Bearing Housing Ends (Slide-In Style)

Universal Shock Mounts

Large Urethane Bump Stop Puck

Brake Hose Bulkhead Fitting Tab (Weld-On)

Late Model Large Bearing Axle Bearing Retainer Plates (Wilwood Brakes)

Stainless Braided Caliper Flex Hose Kit (for Wilwood Brakes)

U-Joint U-Bolt Kit for 1350 Yoke (Plated)

1 Ton Inner Knuckle Gusset

Shock stud with 5/8 inch shank

'64-'73 Mustang Spring Plates w/ 3" U-Bolts

Leaf Spring Pads - 3" Tube x 2" Wide