| Vehicle Fitment | 2018 and newer Jeep Wrangler JL and JLU |
| F10 Axle | ___________________________________________________________________________________ |
| Housing | Currie F9 - Fabricated 9-inch housing with 4130 chromoly center with 3.5-inch diameter. x .375 wall DOM tube |
| Center Section | Currie low-pinion 9-inch nodular iron race case with Daytona style big bearing pinion support |
| Traction | ARB Air Locker (35-Spline) |
| Pinion Yoke | 1350 u-joint |
| Suspension Brackets | Heavy gauge 3/16 steel mounting brackets |
| Width | 70-inches wide (between wheel mounting surfaces) |
| Wheel Bolt Pattern | 8-lug (8 x 6.5 in.) with 9/16 studs |
| Finish | Black satin powder coat |
| Front F10 Axle | ___________________________________________________________________________________ |
| Axles | Currie Performance 35-spline (1.5” diameter) 4340 Chromoly inner and outer axle shafts with 1480 u-joints, Currie Performance double splined full-floating (35-spline 1.5-inch diameter) 4340 heat-treated chromoly |
| End Forgings | Currie 1-ton heavy-duty forged steel inner C’s |
| Steering Knuckles | Currie 1-ton nodular iron steering knuckles machined and keyed for high-steer arms |
| Unit Bearings | 1-ton unit bearings with JK tone rings installed for ABS and ESP retention |
| Hubs | Warn Premium locking 35-spline hubs |
| Brake Rotors | 13-inch F-350 vented rotors, Upgraded 13.750-inch vented rotors |
| Brake Calipers | F-350 Dual-piston calipers, Jeep Gladiator rear calipers |
| Tie Rod | 1-ton 1.357 in. OD x .375 wall heat treated chromoly tube with forged tie rod ends |
| Geometry | Optimized for vehicles with 3 to 4-inches of lift (5 degrees of pinion angle and 5 degrees of caster angle), Optimized for 4-inchs of lift with 5 degrees of pinion |
| Track Bar / Stabilizer Mount | Integrated raised track bar and ram-assist mount. Trac bar mount height set for 3 to 4 inch lift, ram-assist mount setup for PSC 8-inch travel ram |
| Rear F10 Axle | ___________________________________________________________________________________ |
| Floater Spindle | Currie Performance 2.5-inch heat-treated 4140 Chromoly spindles, supports 35 or 40-spline axles |
| Floater Hub | Currie Performance billet full-floating hubs with 35-spline drive flanges, JK tone rings installed for ABS and ESP retention |
| Parking Brake | Modified JK EOM backing plate and parking brake assembly |