Vehicle Fitment
|
2007 thru 2018 Jeep Wrangler JK and JKU |
F10 Axle
|
___________________________________________________________________________________ |
Housing
|
Currie F9 - Fabricated 9-inch housing with 4130 chromoly center with 3.5-inch diameter. x .375 wall DOM tube |
Center Section
|
Currie low-pinion 9-inch nodular iron race case with Daytona style big bearing pinion support |
Traction
|
ARB Air Locker (35-Spline) |
Pinion Yoke
|
1350 u-joint |
Suspension Brackets
|
Heavy gauge 3/16 steel mounting brackets |
Width
|
70-inches wide (between wheel mounting surfaces) |
Wheel Bolt Pattern
|
8-lug (8 x 6.5 in.) with 9/16 studs |
Finish
|
Black satin powder coat |
Front F10 Axle
|
___________________________________________________________________________________ |
Axles
|
Currie Performance 35-spline (1.5” diameter) 4340 Chromoly inner and outer axle shafts with 1480 u-joints, Currie Performance double splined full-floating (35-spline 1.5-inch diameter) 4340 heat-treated Chromoly |
End Forgings
|
Currie 1-ton heavy-duty forged steel inner C’s |
Steering Knuckles
|
Currie 1-ton nodular iron steering knuckles machined and keyed for high-steer arms |
Unit Bearings
|
1-ton unit bearings with JK tone rings installed for ABS and ESP retention |
Hubs
|
Warn Premium locking 35-spline hubs |
Brake Rotors
|
13.75-inch vented rotors, 13.750-inch vented rotors |
Brake Calipers
|
Dual-piston calipers, Jeep Gladiator rear calipers |
Tie Rod
|
1-ton 1.357 in. OD x .375 wall heat treated chromoly tube with forged tie rod ends |
Geometry
|
Optimized for vehicles with 3 to 4-inches of lift (5 degrees of pinion angle and 5 degrees of caster angle), Optimized for 4-inchs of lift with 5 degrees of pinion |
Track Bar Mount
|
Integrated raised track bar and ram-assist mount. Trac bar mount height set for 3 to 4 inch lift, ram-assist mount setup for PSC 8-inch travel ram |
Rear F10 Axle
|
___________________________________________________________________________________ |
Floater Spindle
|
Currie Performance 2.5-inch heat-treated 4140 Chromoly spindles, supports 35 or 40-spline axles |
Floater Hub
|
Currie Performance billet full-floating hubs with 35-spline drive flanges, JK tone rings installed for ABS and ESP retention |
Parking Brake
|
Modified JK EOM backing plate and parking brake assembly |