Products specifications
Vehicle Fitment 2020 and newer Jeep Gladiator Truck
Center Section Currie LP60 nodular Iron low-pinion center section
Gear Set Standard Dana 60™ low-pinion
Pinion Yoke 1350 u-joint
Differential Cover Currie nodular-iron cover with gasketed fill plug with dipstick, Red
Axle Tubes 3.5 in. diameter x .375 in. wall DOM tube
Axle Bearings Set 80 tapered roller bearing
Axles Currie Performance semi-floating, 40-spline (1.7” diameter) axles with tone rings for ABS/EPS retention
Brake Rotors Not included, reuses the stock Gladiator rear rotors
Brake Calipers Not included, reuses the stock Gladiator rear calipers
Suspension Brackets Heavy gauge 3/16” steel mounting brackets
Geometry Optimized for stock height up to 4” of lift
Width 68-inches between wheel mounting surfaces (stock Gladiator width)
Wheel Bolt Pattern 5 on 5 inch with 14 MM studs (standard Gladiator pattern)
Finish Black satin powder coat