Vehicle Fitment
|
2018 and newer Jeep Wrangler JL (Not compatible with 392) |
F10 Axle
|
___________________________________________________________________________________ |
Housing
|
Currie F10 - Fabricated 10-inch housing with 3.5-inch diameter. x .375 wall DOM tube |
Center Section
|
Currie high-pinion 10-inch nodular iron race case with 35-spline bearing pinion support |
Traction
|
ARB Air Locker (35-Spline) |
Pinion Yoke
|
1350 u-joint |
Suspension Brackets
|
Heavy gauge 3/16 in. steel mounting brackets |
Width
|
70-inches wide (between wheel mounting surfaces) |
Wheel Bolt Pattern
|
8-lug (8 x 6.5 in.) with 9/16 in. studs |
Finish
|
Black satin powder coat |
Front F10 Axle
|
___________________________________________________________________________________ |
Axles
|
Currie Performance 35-spline (1.5 in. diameter) 4340 chromoly inner and outer axle shafts with 1480 u-joints, Currie Performance double splined full-floating (35-spline 1.5 in. diameter) 4340 heat-treated chromoly |
End Forgings
|
Currie 1-ton heavy-duty forged steel inner C’s |
Steering Knuckles
|
Currie 1-ton nodular iron steering knuckles machined and keyed for high-steer arms |
Unit Bearings
|
1-ton unit bearings with tone rings installed for ABS and ESP retention |
Hubs
|
Warn Premium locking 35-spline hubs |
Brake Rotors
|
14.25 in. vented 8-lug rotors, 13.750 in. vented rotors |
Brake Calipers
|
Jeep Gladiator dual-piston calipers, Jeep Gladiator truck OE calipers |
Tie Rod
|
1-ton 1.357 in. OD x .375 wall heat treated chromoly tube with forged tie rod ends |
Geometry
|
Optimized for vehicles with 3 to 4 in. of lift (5 degrees of pinion angle and 5 degrees of caster angle), Optimized for 4 in. of lift with 5 degrees of pinion |
Track Bar Mount
|
Integrated raised track bar and ram-assist mount. Trac bar mount height set for 3 to 4 in. lift, ram-assist mount setup for PSC 8 in. travel ram |
Rear F10 Axle
|
___________________________________________________________________________________ |
Floater Spindle
|
Currie Performance 2.5 in. heat-treated 4140 chromoly spindles, supports 35 or 40-spline axles |
Floater Hub
|
Currie Performance billet full-floating hubs with 35-spline drive flanges, tone rings installed for ABS and ESP retention |
Parking Brake
|
Modified Jeep Gladiator EOM backing plate and parking brake assembly |