Search
Filters

F9 fabricated 9-inch frontend assembly for the 2007 and up Jeep Wrangler JK


*** CONFIGURE OPTIONS TO BUILD AND PRICE ***

SKU: JK-F9300F
*
*
*
*
*
*
*
*
$5,960.00
WARNING: Cancer and Reproductive Harm  - www.P65Warning.ca.gov

 

The F9 fabricated 9-inch frontend assembly for the 2007 and up Jeep Wrangler JK includes the complete housing with the Hi-Form 50 steel housing center, 3" x .375" wall d.o.m. steel tubes, 1 ton inner knuckles, and all new heavy duty Currie Jeep JK suspension brackets mounted

Upper control arm brackets are equipped with Johnny Joint® rod ends for maximum articulation. Axles shafts are the Currie performance 4340 35 spline inner and outer with Spicer 1480 u-joints. Outer assemblies include 1 ton outer knuckles featuring Currie "high steer" steering arm and ball joints installed, Currie exclusive 1 ton unit bearings with 5 on 5 1/2" wheel bolt pattern and JK tone rings allowing for ABS and ESP retention, 13" vented rotors (over 1" greater diameter than stock for increased braking), zinc plated caliper brackets that allow the use of the stock JK front calipers

Currie drive flanges or premium manual locking hubs, and our heavy duty 1 3/8" o.d. 4130 chrome moly tie rod with tie rod ends. The only parts needed to complete this unit is a 9-inch high or low pinion 3rd. member, and assembly of the unit! Your JK's stock calipers transfer over! NOTES: This unit is 68.75" wide. This unit requires the use of 17" wheels.

The F9 fabricated 9-inch frontend assembly for the 2007 and up Jeep Wrangler JK includes the complete housing with the Hi-Form 50 steel housing center, 3" x .375" wall d.o.m. steel tubes, 1 ton inner knuckles, and all new heavy duty Currie Jeep JK suspension brackets mounted

Upper control arm brackets are equipped with Johnny Joint® rod ends for maximum articulation. Axles shafts are the Currie performance 4340 35 spline inner and outer with Spicer 1480 u-joints. Outer assemblies include 1 ton outer knuckles featuring Currie "high steer" steering arm and ball joints installed, Currie exclusive 1 ton unit bearings with 5 on 5 1/2" wheel bolt pattern and JK tone rings allowing for ABS and ESP retention, 13" vented rotors (over 1" greater diameter than stock for increased braking), zinc plated caliper brackets that allow the use of the stock JK front calipers

Currie drive flanges or premium manual locking hubs, and our heavy duty 1 3/8" o.d. 4130 chrome moly tie rod with tie rod ends. The only parts needed to complete this unit is a 9-inch high or low pinion 3rd. member, and assembly of the unit! Your JK's stock calipers transfer over! NOTES: This unit is 68.75" wide. This unit requires the use of 17" wheels.