For the aficionado who wants the best, our 9-inch replica housings should interest you! This 100% new Ford 9-inch housing features our heavy-duty round back housing with axle tubes that are swaged from 3 inches down to 2.250 inches and small bearing housing ends installed (just like the original) with replica leaf spring pads mounted in the OE location
Currie 9-inch replica housings are a direct bolt-in replacement for the stock factory 8-inch or 9-inch housings and will accept the original stock 9-inch housing's 28-spline third member, axles and wheel bearings as well as the OE brake components
If upgrading from an OE 8-inch rearend (typically the case), a new 9-inch 28-spline third member will be required to complete the installation
This housing is not intended for Concourse level restoration projects, as the weld appearance (ours look much better), vent location and style differ from the original equipment
Standard Features
 |
|
Currie Round Back Housing – 100% new, 9-inch heavy-duty replica housing w/o fill plug |
|
|
|
 |
|
Swaged Axle Tubes - Replica swaged axle tubes made from strong .188 wall DOM tube eliminate the bending issues associated with the OE rearends. The tubes are swaged from 3-inches down to 2.250-inches to keep that classic appearance |
|
|
|
 |
|
Spring Pads - Replica heavy-duty spring pads are located at the stock position, for a direct bolt-in fit |
|
|
|
 |
|
Housing Ends - Billet small bearing housing ends accept the early stock axles, retainers, and brake hardware |